最新免费av在线观看,亚洲综合一区成人在线,中文字幕精品无码一区二区三区,中文人妻av高清一区二区,中文字幕乱偷无码av先锋

TPS61040 Datasheet

  • TPS61040

  • 采用 SOT-23 封裝用于 LCD 和白光 LED 的 28V 400mA 開關升壓轉...

  • 19頁

  • TI

掃碼查看芯片數據手冊

上傳產品規格書

PDF預覽

TPS61040
TPS61041
SLVS413B 鈥?OCTOBER 2002 鈥?REVISED MAY 2004
www.ti.com
The larger the feedforward capacitor the worse the line regulation of the device. Therefore, when concern for line
regulation is paramount, the selected feedforward capacitor should be as small as possible. See the next section
for more information about line and load regulation.
LINE AND LOAD REGULATION
The line regulation of the TPS61040/41 depends on the voltage ripple on the feedback pin. Usually a 50 mV
peak-to-peak voltage ripple on the feedback pin FB gives good results.
Some applications require a very tight line regulation and can only allow a small change in output voltage over a
certain input voltage range. If no feedforward capacitor C
FF
is used across the upper resistor of the voltage
feedback divider, the device has the best line regulation. Without the feedforward capacitor the output voltage
ripple is higher because the TPS61040/41 shows output voltage bursts instead of single pulses on the switch pin
(SW), increasing the output voltage ripple. Increasing the output capacitor value reduces the output voltage
ripple.
If a larger output capacitor value is not an option, a feedforward capacitor C
FF
can be used as described in the
previous section. The use of a feedforward capacitor increases the amount of voltage ripple present on the
feedback pin (FB). The greater the voltage ripple on the feedback pin (鈮?0 mV), the worse the line regulation.
There are two ways to improve the line regulation further:
1. Use a smaller inductor value to increase the switching frequency which will lower the output voltage ripple,
as well as the voltage ripple on the feedback pin.
2. Add a small capacitor from the feedback pin (FB) to ground to reduce the voltage ripple on the feedback pin
down to 50 mV again. As a starting point, the same capacitor value as selected for the feedforward capacitor
C
FF
can be used.
OUTPUT CAPACITOR SELECTION
For best output voltage filtering, a low ESR output capacitor is recommended. Ceramic capacitors have a low
ESR value but tantalum capacitors can be used as well, depending on the application.
Assuming the converter does not show double pulses or pulse bursts on the switch node (SW), the output
voltage ripple can be calculated as:
I
DV
out
+
out
Cout
I
L
1
P
鈥?/div>
fS(Iout) Vout
)
Vd鈥揤in
)
I
P
ESR
(7)
Where:
I
P
= Peak current as described in the previous
peak current control
section
L = Selected inductor value
I
out
= Nominal load current
fS (I
out
) = Switching frequency at the nominal load current as calculated previously
Vd = Rectifier diode forward voltage (typically 0.3V)
C
out
= Selected output capacitor
ESR = Output capacitor ESR value
Refer to Table 2 and
typical applications
section for choosing the output capacitor.
Table 2. Recommended Input and Output Capacitors
DEVICE
CAPACITOR
4.7 碌F/X5R/0805
10 碌F/X5R/0805
TPS61040/41
1.0 碌F/X7R/1206
1.0 碌F/X5R/1206
4.7 碌F/X5R/1210
VOLTAGE RATING
6.3 V
6.3 V
25 V
35 V
25 V
COMPONENT SUPPLIER
Tayo Yuden JMK212BY475MG
Tayo Yuden JMK212BJ106MG
Tayo Yuden TMK316BJ105KL
Tayo Yuden GMK316BJ105KL
Tayo Yuden TMK325BJ475MG
COMMENTS
C
IN
/C
OUT
C
IN
/C
OUT
C
OUT
C
OUT
C
OUT
12

TPS61040 PDF文件相關型號

TPS61041,TPS61043

TPS61040相關型號PDF文件下載

掃碼下載APP，
一鍵連接廣大的電子世界。

在線人工客服

買家服務：
賣家服務：
技術客服：

0571-85317607

網站技術支持

13606545031

客服在線時間周一至周五
9:00-17:30

關注官方微信號，
第一時間獲取資訊。

建議反饋

聯系人：

聯系方式：

按住滑塊，拖拽到最右邊
>>
感謝您向阿庫提出的寶貴意見，您的參與是維庫提升服務的動力！意見一經采納，將有感恩紅包奉上哦！