Excellence in Electronics
Attention Points In Handling
SLA580 Serise
Through-hole LEDs
Visual light emitting diodes does not contain reinforcement materials such as glass fillers.
Therefore if sudden thermal and mechanical shock are given, destruction or inferiority of luminous
intensity may occur. Please take care of the handling.
鈻燜IXATION
METHOD
1.ATTENTION POINTS
1-1) Please do not give excessive heat over storage temperature to resin.
However, In case that the product has to be heated in oven for the glue fixing,
it can stand under (125鈩僊AX, 120secMAX) condition.
1-2) Please avoid stress to resin at high temperature.
2.TERMINATION PROCESSING
2-1) In case of termination processing, please fix the termination
processing position, and process before reverse side of LED body.
Please process before soldering.
If stress is given during processing, It may cause non-lighting failure.
To be fixed
3.ASSEMBLY ON PC BOARD
3-1) In case of soldering on PCB, if the operation is done with stress, it may cause non-lighting
failure during soldering or using.
鈼?/div>
鈼?/div>
脳
3-2) Therefore please design holes of PCB suitable for termination space or termination space
after forming, and avoid the stress.
Especially in case of clinch to PCB, please do not leave remained stress.
Enough evaluation is requested before deciding assembly conditions.
Please consult with us if any problems emerged in the evaluation stage.
MIN 15擄
MIN 45擄
Anode (GaAlAs chip : Cathode)
REV. : A
ROHM CO., LTD.
PAGE:1/2
1
2
